Place the Victory Malt in a plastic zip-lock sandwich bag and crack it using a rolling pin.
In a good size pot (around 4 Litres) bring 2 litres of water to approximately 60-70°C.
Add the crushed Victory Malt (we recommend wrapping in a mesh cleaning cloth, pulled straight from
the wrapper), and let steep for about 30 minutes.
Remove the Victory Malt by gathering up the corners of the mesh cloth and lift, allowing the liquid to
drain from the malt back into the pot.
Add pot to the stove and bring to the boil for 5 minutes.
Remove from heat and set pot in an ice bath to cool for 15 minutes.
Strain the wort into your Fermenting Vessel (FV) and add the Mr Beer North West Pale Ale, stir to
dissolve.
Fill the FV with cold water to the 5 litre mark.
Check the temperature and top up to the 10 litre mark with hot or cold water to get as close to 18°C
as possible.
Sprinkle the brew can yeast and fit the lid.

Place the FV in a location out of direct sunlight and try to ferment between 18C - 24C.
On Day 5 or once the foam has died down, add the Cashmere and Motueka Hops (we recommend
wrapping them in a mesh cleaning cloth, pulled straight from the wrapper).
At about day 7 check the specific gravity (SG).
Check the SG again the following day and so on.

The brew is ready once the SG has stabilised over a couple of days, expect about 1009-1014.
Gently fill clean PET bottles to about 3cm from the top.
Add 2 carbonation drops per bottle and secure the caps.
Store the bottles upright in a location out of direct sunlight at or above 18C.

After at least two weeks, check for sufficient carbonation by squeezing the PET bottles.
Bottles kept unrefrigerated should improve with age.
When ready to drink, chill the bottles upright.
The chilled beer may be poured into clean glassware, leaving the sediment behind.
Expect the alcohol content to be approximately 4.9% ABV.